InteliLite 9 Global Guide
46
5.1.4 Binary outputs MRS
Number Description Function
BOUT1 Starter motor control STARTER (PAGE 344)
BOUT2 Fuel solenoid valve FUEL SOLENOID (PAGE 326)
BOUT3 Generator circuit breaker control GCB CLOSE/OPEN (PAGE 327)
BOUT4 Activation of any devices before start PRESTART (PAGE 341)
BOUT5 Gen-set can be connected to load READY TO LOAD (PAGE 343)
BOUT6 Indication of unconfirmed alarm ALARM (PAGE 322)
5.1.5 Analog inputs
Number Configured sensor Function
AIN1 VDO 10 Bar OIL PRESSURE (PAGE 355)
AIN2 VDO40-120°C COOLANT TEMP (PAGE 353)
AIN3 VDOLevel % FUEL LEVEL (PAGE 354)
5.2 Controller configuration and PC tools
connection
5.2.1 USB 46
5.2.2 RS232/RS485 47
5.2.3 Ethernet 49
6 back to Controller setup
This chapter contains brief introduction into the specifics of firmware and archive upload and connection of
various PC tools to the controller. If you require detailed information on each PC tool please use the included
Help in those PC tools or download their Reference Guides.
5.2.1 USB
You may connect to the controller using the USB port. In this case standard USB A to B cable should be used.
To Next Page
Loading...
Need help?
General
