InteliLite 9 Global Guide
186
Setpoint group Engine settings Related FW 1.1.0
Range [units] 0 .. 900 [s]
Default value 10 s Alternative config NO
Step 1 s
Comm object 14433 Related applications AMF, MRS
Config level Standard
Setpoint visibility Visible only if ECU is configuredd
Description
Delay for Fuel level which is send from ECU.
ECU Fuel Level Delay
6 back to List of setpoints
Setpoint group Engine settings Related FW 1.1.0
Range [units] Disabled / 1 .. 60 [s]
Default value 30 s Alternative config YES
Step 1 s
Comm object 10685 Related applications AMF, MRS
Config level Advanced
Setpoint visibility Visible only if the logical binary output FUEL PUMP (PAGE 327) is configured
Description
If the controller does not see the fuel increase during fuel transfer within this time alarm Wrn Fuel Transfer
Failed (page 371) will be displayed and the FUEL PUMP (PAGE 327) will be turned off. Alarm Wrn Fuel
Transfer Failed (page 371) will be displayed but this alarm becomes immediately inactive and it will be
possible to delete this message by the Fault reset button. If the fault is deleted the controller will initiate the
transfer again.
Transfer Wrn Delay
6 back to List of setpoints
To Next Page
Loading...
Need help?
General
