InteliLite 9 Global Guide
392
Image 9.7 Cross-wired cable
Power consumption
120 mA / 8 VDC
82 mA / 12 VDC
35 mA / 24 VDC
25 mA / 36 VDC
Technical data
Module setup
All settings related to the module are to be adjusted via the controller setpoints. The respective setpoints are
located in the setpoint Group: CM-Ethernet (page 231).
All actual operational values like actual IP address etc. are available in controller values in a specific group as
well.
On module is also indication LED. Following states are indicated via this LED:
bootloader mode with communication with controller - green LED is blinking in period 50ms/50ms
bootloader mode without communication with controller - red LED is blinking in period 50ms/50ms
operating mode with communication with controller - green LED is blinking in period 500ms/500ms
operating mode without communication with controller - red LED is blinking in period 500ms/500ms
test mode - green LED is blinking in period 250ms/250ms
Firmware upgrade
Download the newest FWof module from ComAp website (in form of PSI file or installation package)
Instal package to computer or open PSI to instal it into InteliConfig
Plug the module into the controller and power the controller on.
Open a connection with controller via InteliConfig
Go the menu Tools -> Firmware upgrade, select the Plug-in modules tab and select the appropriate firmware
you want to program into the module (in InteliConfig).
Press the OK button to start upgrade of firmware.
The firmware update process may be performed via any kind of connection including connection via the same
module in which the firmware is to be updated. The connection is reestablished again automatically when the
update process is finished.
To Next Page
Loading...
Need help?
General
