TACACS+ Commands
OL-32830-01 Command Line Interface Reference Guide 1002
51
Parameters
•
timeout
—Specifies the timeout value in seconds. (Range: 1-30).
Default Configuration
The default timeout value is 5 seconds.
Command Mode
Global Configuration mode
Example
The following example sets the timeout value to 30 for all TACACS+ servers.
switchxxxxxx(config)#
tacacs-server timeout
30
51.6 show tacacs
To display configuration and statistical information for a TACACS+ server, use the
show tacacs Privileged EXEC mode command.
Syntax
show tacacs [
ip-address
]
Parameters
•
ip-address
—Specifies the TACACS+ server name, IPv4 or IPv6 address.
Default Configuration
If
ip-address
is not specified, information for all TACACS+ servers is displayed.
Command Mode
Privileged EXEC mode
To Next Page
Loading...
Need help?
General