Voice VLAN Commands
1097 OL-32830-01 Command Line Interface Reference Guide
57
10 CDP 00:00:12:ea:87:dc gi11
10 CDP 00:00:aa:aa:89:dc po1
57.3 voice vlan state
To set the type of voice VLAN that is functional on the device or disable voice
VLAN entirely, use the voice vlan state Global Configuration mode command.
The no format of the command returns to the default.
Syntax
voice vlan state {{
auto-enabled
|
auto-triggered
} [
ipv6
]} |
oui-enabled
|
disabled
}
no voice vlan state
Parameters
• auto-enabled—Auto Voice VLAN is enabled.
• auto-triggered—Auto Voice VLAN on the switch is in standby and is put into
operation when the switch detects a CDP device advertising a voice VLAN
or if a voice VLAN ID is configured manually on the switch.
• ipv6— Auto VLAN is enabled on IPv6 mDNS.
• oui-enabled—Voice VLAN is of type OUI.
• disabled—Voice VLAN is disabled.
Default Configuration
auto-triggered on ipv4
Command Mode
Global Configuration mode
User Guidelines
By factory default, CDP, LLDP, and LLDP-MED are enabled on the switch. In
addition, manual Smartport mode and Basic QoS with trusted DSCP is enabled.
All ports are members of default VLAN 1, which is also the default Voice VLAN.
To Next Page
Loading...
Need help?
General