Virtual Local Area Network (VLAN) Commands
OL-32830-01 Command Line Interface Reference Guide 1084
56
• The port is added as untagged to the primary VLAN and to the secondary
VLAN.
• The PVID is set to the VLAN-ID of the secondary VLAN.
• The port ingress filtering is enabled.
The port association configuration for an isolated secondary VLAN includes:
• The port is added as untagged only to the primary VLAN and is not added
to the secondary VLAN.
• The PVID is set to the VLAN-ID of the secondary VLAN.
• The port ingress filtering is disabled.
Example
The following example set port gi14
to secondary VLAN 20 in primary VLAN 10.
switchxxxxxx(config)#
interface
gi14
switchxxxxxx(config-if)#
switchport private-vlan host-association
10 20
56.32 show vlan private-vlan
Use the show vlan private-vlan EXEC mode command to display private VLAN
information.
Syntax
show vlan private-vlan
[tag
vlan-id
]
Parameters
• tag
vlan-id
—Primary VLAN that represent the private VLAN to be displayed.
Default Configuration
All private VLANs are displayed.
Command Mode
User EXEC mode
To Next Page
Loading...
Need help?
General