Link Layer Discovery Protocol (LLDP) Commands
OL-32830-01 Command Line Interface Reference Guide 656
30
Parameters
This command has no arguments or keywords.
Default Configuration
None
Command Mode
Global Configuration mode
User Guidelines
In Auto mode, the Voice VLAN feature determines on which interfaces to advertise
the network policy TLV with application type voice, and controls the parameters of
that TLV.
To enable the auto generation of a network policy based on the auto voice VLAN,
there must be no manually pre-configured network policies for the voice
application
In Auto mode, you cannot manually define a network policy for the voice
application using the lldp med network-policy (global) command.
Example
switchxxxxxx(config)#
lldp med network-policy voice auto
30.13 lldp notifications
To enable/disable sending LLDP notifications on an interface, use the lldp
notifications Interface (Ethernet) Configuration mode command. To restore the
default configuration, use the no form of this command.
Syntax
lldp notifications
{enable | disable}
no lldp notifications
Parameters
• enable—Enables sending LLDP notifications.
• disable—Disables sending LLDP notifications.
To Next Page
Loading...
Need help?
General