Voice VLAN Commands
1101 OL-32830-01 Command Line Interface Reference Guide
57
30-Apr-2011 02:01:05 %LINK-W-Down: Vlan 50
30-Apr-2011 02:01:05 %LINK-W-Down: Vlan 100
30-Apr-2011 02:01:06 %LINK-I-Up: Vlan 50
30-Apr-2011 02:01:06 %LINK-I-Up: Vlan 100
switchxxxxxx#
show voice vlan
Administrate Voice VLAN state is auto-triggered
Operational Voice VLAN state is auto-enabled
Best Local Voice VLAN-ID is 100
Best Local VPT is 5 (default)
Best Local DSCP is 46 (default)
(Following is the new active source)
Agreed Voice VLAN is received from switch b0:c6:9a:c1:da:00
Agreed Voice VLAN priority is 2 (active CDP device)
Agreed Voice VLAN-ID is 100
Agreed VPT is 5
Agreed DSCP is 46
Agreed Voice VLAN Last Change is 11-Apr-30 02:01:02
57.5 voice vlan id
To statically configure the VLAN identifier of the voice VLAN, use the voice vlan id
Global Configuration mode command. To return the voice VLAN to the default
VLAN (1), use the no format of the command.
Syntax
voice vlan id
vlan-id
no voice vlan id
Parameters
vlan id
vlan-id
—Specifies the voice VLAN (range 1-4094).
To Next Page
Loading...
Need help?
General