SSH Client Commands
947 OL-32830-01 Command Line Interface Reference Guide
48
Syntax
ipv6 ssh-client source-interface
interface-id
no ipv6 ssh-client source-interface
Parameters
•
interface-id
—(Optional) Specifies the source interface.
Default Configuration
The IPv6 source address is the IPv6 address defined of the outgoing interface and
selected in accordance with RFC6724.
Command Mode
Global Configuration mode
User Guidelines
If the source interface is the outgoing interface then the IPv6 address defined on
the interfaces and selected in accordance with RFC 6724.
If the source interface is not the outgoing interface then the minimal IPv4 address
defined on the source interface and with the scope of the destination IPv6
address is applied.
If there is no available IPv6 source address, a SYSLOG message is issued when
attempting to communicate with an IPv6 SSH servers.
Example
The following example configures the VLAN 10 as the source interface.
switchxxxxxx(config)#
ipv6 ssh-client source-interface vlan 100
48.9 ip ssh-client username
To configure the SSH client username of the switch, use the ip ssh-client
username command in Global Configuration mode.
To return to default, use the no form of the command.
To Next Page
Loading...
Need help?
General