Cisco 300 Series User Manual

IPv6 Tunnel Commands
1017 OL-32830-01 Command Line Interface Reference Guide
53
53.2 tunnel isatap solicitation-interval
To set the time interval between unsolicited router solicitation messages, use the
tunnel isatap solicitation-interval command in Global Configuration mode. To
restore the default configuration, use the no form of this command.
Syntax
tunnel isatap solicitation-interval
seconds
no tunnel isatap solicitation-interval
Parameters
• seconds —Specifies the time interval in seconds between ISATAP router
solicitation messages. (Range: 10–3600).
Default Configuration
The default time interval between ISATAP router solicitation messages is 10
seconds.
Command Mode
Global Configuration mode
User Guidelines
This command determines the interval between unsolicited router solicitation
messages sent to discovery an ISATAP router.
Example
The following example sets the time interval between ISATAP router solicitation
messages to 30 seconds.
switchxxxxxx(config)# tunnel isatap solicitation-interval 30
53.3 tunnel isatap robustness
To configure the number of router solicitation refresh messages that the device
sends, use the tunnel isatap robustness command in Global Configuration mode.
To restore the default configuration, use the no form of this command.

Cisco 300 Series Specifications

General

Brand	Cisco
Model	300 Series
Category	Switch
Language	English