Cisco 300 Series User Manual

802.1X Commands
OL-32830-01 Command Line Interface Reference Guide 46
2
Command Mode
Global Configuration mode
User Guidelines
You can select either authentication by a RADIUS server, no authentication (none),
or both methods.
If you require that authentication succeeds even if no RADIUS server response
was received, specify none as the final method in the command line.
Example
The following example sets the 802.1X authentication mode to RADIUS server
authentication. Even if no response was received, authentication succeeds.
switchxxxxxx(config)# aaa authentication dot1x default radius none
2.2 authentication open
To enable open access (monitoring mode) on this port, use the authentication
open command in interface configuration mode. To disable open access on this
port, use the no form of this command.
Syntax
authentication open
no authentication open
Parameters
This command has no arguments or keywords.
Default Configuration
Disabled.
Command Mode
Interface (Ethernet) Configuration mode

Cisco 300 Series Specifications

General

Brand	Cisco
Model	300 Series
Category	Switch
Language	English