Cisco 300 Series User Manual

CDP Commands
207 OL-32830-01 Command Line Interface Reference Guide
8
User Guidelines
Use the cdp source-interface command to specify an interface whose minimal IP
address will be advertised in the TVL instead of the minimal IP address of the
outgoing interface.
Example
switchxxxxxx(config)# cdp source-interface gi11
8.8 cdp log mismatch duplex
Use the cdp log mismatch duplex Global and Interface Configuration mode
command to enable validating that the duplex status of a port received in a CDP
packet matches the ports actual configuration. If not, a SYSLOG duplex mismatch
message is generated. The no format of the CLI command disables the generation
of the SYSLOG messages.
Syntax
cdp log mismatch duplex
no cdp log mismatch duplex
Parameters
N/A
Default Configuration
The switch reports duplex mismatches from all ports.
Command Mode
Global Configuration mode
Interface (Ethernet) Configuration mode
Example
switchxxxxxx(config)# interface gi11
switchxxxxxx(config-if)# cdp log mismatch duplex

Cisco 300 Series Specifications

General

Brand	Cisco
Model	300 Series
Category	Switch
Language	English