To Next Page

To Previous Page

Network Management Protocol (SNMP) Commands

OL-32830-01 Command Line Interface Reference Guide 874

45.12 snmp-server filter

To create or update an SNMP server notification filter, use the snmp-server filter

Global Configuration mode command. To remove a notification filter, use the no

form of this command.

Syntax

snmp-server filter

filter-name

oid-tree {included | excluded}

no snmp-server filter

filter-name

[

oid-tree

]

Parameters

• filter-name—Specifies the label for the filter record that is being updated or

created. The name is used to reference the filter in other commands.

(Length: 1–30 characters)

• oid-tree—Specifies the ASN.1 subtree object identifier to be included or

excluded from the view. To identify the subtree, specify a text string

consisting of numbers, such as 1.3.6.2.4, or a word, such as System. Replace

a single sub-identifier with the asterisk (*) wildcard to specify a subtree

family; for example, 1.3.*.4.

• included—Specifies that the filter type is included.

• excluded—Specifies that the filter type is excluded.

Default Configuration

No view entry exists.

Command Mode

Global Configuration mode

User Guidelines

This command can be entered multiple times for the same filter. If an object

identifier is included in two or more lines, later lines take precedence. The

command's logical key is the pair (filter-name, oid-tree).

Cisco 300 Series User Manual

Other manuals for Cisco 300 Series