Cisco 300 Series User Manual

Ethernet Configuration Commands
OL-32830-01 Command Line Interface Reference Guide 400
18
Command Mode
Privileged EXEC mode
Example
The following example clears the statistics counters for gi11.
switchxxxxxx# clear counters gi11
18.14 set interface active
To reactivate an interface that was shut down, use the set interface active
Privileged EXEC mode command.
Syntax
set interface active
{interface-id}
Parameters
interface-id—(Optional) Specifies an interface ID. The interface ID can be one of
the following types: Ethernet port or port-channel.
Command Mode
Privileged EXEC mode
User Guidelines
This command is used to activate interfaces that were configured to be active, but
were shut down by the system.
Example
The following example reactivates gi11.
switchxxxxxx# set interface active gi11

Cisco 300 Series Specifications

General

Brand	Cisco
Model	300 Series
Category	Switch
Language	English