Cisco 300 Series User Manual

Address Table Commands
OL-32830-01 Command Line Interface Reference Guide 142
5
Example
The following example enables bridge Multicast filtering.
switchxxxxxx(config)# bridge multicast filtering
5.2 bridge multicast mode
To configure the Multicast bridging mode, use the bridge multicast mode Interface
(VLAN) Configuration mode command. To return to the default configuration, use
the no form of this command.
Syntax
bridge multicast mode
{mac-group | ipv4-group | ipv4-src-group}
no bridge multicast mode
Parameters
• mac-group—Specifies that Multicast bridging is based on the packet's
VLAN and MAC address.
• ipv4-group—Specifies that Multicast bridging is based on the packet's
VLAN and MAC address for non-IPv4 packets, and on the packet's VLAN
and IPv4 destination address for IPv4 packets.
• ipv4-src-group—Specifies that Multicast bridging is based on the packet's
VLAN and MAC address for non-IPv4 packets, and on the packet's VLAN,
IPv4 destination address and IPv4 source address for IPv4 packets.
Default Configuration
The default mode is mac-group.
Command Mode
Interface (VLAN) Configuration mode
User Guidelines
Use the mac-group option when using a network management system that uses a
MIB based on the Multicast MAC address. Otherwise, it is recommended to use

Cisco 300 Series Specifications

General

Model	Cisco 300 Series
Category	Switch
Dimensions	Varies by model
Weight	Varies by model
Power over Ethernet (PoE)	Available on select models
Management	Web-based GUI, SNMP, CLI
VLANs	Up to 256
Security Features	ACLs, 802.1X, Port Security
Humidity	10% to 90% non-condensing
Ports	8, 16, 24, 48