Cisco 300 Series User Manual

Power over Ethernet (PoE) Commands
OL-32830-01 Command Line Interface Reference Guide 734
36
Following is a list of port status values:
Port is off – Underload disconnect detected
Port is off – Overload detected
Port is off – Short detected
Port is off - Invalid PD resistor signature detected
Port is on - Valid PD resistor signature detected
Port is off - Power was denied
Port is on - Valid capacitor signature detected
Port is off - Backoff state has occurred
Port is off - Class error has occurred
36.11 show power inline consumption
To display information about the inline power consumption for all interfaces or for a
specific interface, use the show power inline consumption privileged EXEC mode
command.
Syntax
show power inline consumption
[interface-id ]
Parameters
• Interface-id—Specifies an interface ID. The interface ID must be an Ethernet
port.
Default Configuration
Show information for all ports.
Command Mode
Global Configuration mode

Cisco 300 Series Specifications

General

Brand	Cisco
Model	300 Series
Category	Switch
Language	English