Cisco 300 Series User Manual

31
OL-32830-01 Command Line Interface Reference Guide 681
Loopback Detection Commands
31.0
31.1 loopback-detection enable (Global)
To enable the Loopback Detection (LBD) feature globally, use the
loopback-detection enable Global Configuration mode command. To disable the
Loopback Detection feature, use the no form of this command.
Syntax
loopback-detection enable
no loopback-detection enable
Parameters
This command has no arguments or keywords.
Default Configuration
Loopback Detection is disabled.
Command Mode
Global Configuration mode
User Guidelines
This command enables the Loopback Detection feature globally. Use the
loopback-detection enable Interface Configuration mode command to enable
Loopback Detection on an interface.
Example
The following example enables the Loopback Detection feature on the device.
switchxxxxxx(config)# loopback-detection enable

Cisco 300 Series Specifications

General

Brand	Cisco
Model	300 Series
Category	Switch
Language	English