Cisco 300 Series User Manual

Link Layer Discovery Protocol (LLDP) Commands
OL-32830-01 Command Line Interface Reference Guide 680
30
Device type The device type. Indicates whether the sender is a
Network Connectivity Device or Endpoint Device,
and if an Endpoint, to which Endpoint Class it
belongs.
LLDP MED - Network Policy
Application type The primary function of the application defined for
this network policy.
Flags Flags. The possible values are:
Unknown policy: Policy is required by the device,
but is currently unknown.
Tagged VLAN: The specified application type is
using a Tagged VLAN.
Untagged VLAN: The specified application type is
using an Untagged VLAN.
VLAN ID The VLAN identifier for the application.
Layer 2 priority The Layer 2 priority used for the specified
application.
DSCP The DSCP value used for the specified application.
LLDP MED - Power Over Ethernet
Power type The device power type. The possible values are:
Power Sourcing Entity (PSE) or Power Device (PD).
Power Source The power source utilized by a PSE or PD device. A
PSE device advertises its power capability. The
possible values are: Primary power source and
Backup power source. A PD device advertises its
power source. The possible values are: Primary
power, Local power, Primary and Local power.
Power priority The PD device priority. A PSE device advertises the
power priority configured for the port. A PD device
advertises the power priority configured for the
device. The possible values are: Critical, High and
Low.
Power value The total power in watts required by a PD device
from a PSE device, or the total power a PSE device
is capable of sourcing over a maximum length cable
based on its current configuration.
LLDP MED - Location
Coordinates, Civic
address, ECS ELIN.
The location information raw data.
Field Description

Cisco 300 Series Specifications

General

Brand	Cisco
Model	300 Series
Category	Switch
Language	English