Cisco 300 Series User Manual

Link Layer Discovery Protocol (LLDP) Commands
OL-32830-01 Command Line Interface Reference Guide 664
30
switchxxxxxx(config-if)# lldp transmit
30.22 lldp tx-delay
To set the delay between successive LLDP frame transmissions initiated by
value/status changes in the LLDP local systems MIB, use the lldp tx-delay Global
Configuration mode command. To restore the default configuration, use the no
form of this command.
Syntax
lldp tx-delay
seconds
no lldp tx-delay
Parameters
tx-delay
seconds —Specifies the delay in seconds between successive LLDP
frame transmissions initiated by value/status changes in the LLDP local systems
MIB (range: 1-8192 seconds).
Default Configuration
The default LLDP frame transmission delay is 2 seconds.
Command Mode
Global Configuration mode
User Guidelines
It is recommended that the tx-delay be less than 25% of the LLDP timer interval.
Example
The following example sets the LLDP transmission delay to 10 seconds.
switchxxxxxx(config)# lldp tx-delay 10

Cisco 300 Series Specifications

General

Brand	Cisco
Model	300 Series
Category	Switch
Language	English