Cisco 300 Series User Manual

IPv6 Tunnel Commands
OL-32830-01 Command Line Interface Reference Guide 1018
53
Syntax
tunnel isatap robustness
number
no tunnel isatap robustness
Parameters
• number —Specifies the number router solicitation refresh messages that
the device sends. (Range: 1–20).
Default Configuration
The default number of router solicitation refresh messages that the device sends
is 3.
Command Mode
Global Configuration mode
User Guidelines
The router solicitation interval (when there is an active ISATAP router) is the
minimum-router-lifetime that is received from the ISATAP router, divided by
(Robustness + 1).
Example
The following example sets the number of router solicitation refresh messages
that the device sends to 5.
switchxxxxxx(config)# tunnel isatap robustness 5
53.4 tunnel isatap router
To configure a global string that represents a specific automatic tunnel router
domain name, use the tunnel isatap router command in Interface (Tunnel)
Configuration mode. To remove this router name and restore the default
configuration, use the no form of this command.
Syntax
tunnel isatap router
router-name
no tunnel isatap router

Cisco 300 Series Specifications

General

Brand	Cisco
Model	300 Series
Category	Switch
Language	English