IPv6 Tunnel Commands
OL-32830-01 Command Line Interface Reference Guide 1022
53
• The used IPv4 is removed from the switch configuration.
• The tunnel mode is changed.
When the tunnel local IPv4 address is changed the IPv6 interface on the tunnel is
re-enabled that causes removing static IPv6 configuration on the tunnel (for
example, global IPv6 addresses, static IPv6 routes via the tunnel, etc.).
Example
switchxxxxxx(config)#
interface tunnel
1
switchxxxxxx(config-if)#
tunnel source
120.12.3.4
switchxxxxxx(config-if)#
exit
53.7 show ipv6 tunnel
To display information on IPv6 tunnels, use the show ipv6 tunnel command in User
EXEC mode.
Syntax
show ipv6 tunnel [all]
Parameters
• all—(Optional) The switch displays all parameters of the tunnel. If the
keyword is not configured only the tunnel parameters corresponding to its
type are displayed.
Command Mode
User EXEC mode
Examples
Example 1. The following example displays information on the ISATAP tunnel, when
the all keyword is not configured:
switchxxxxxx#
show ipv6 tunnel
Tunnel 2
Tunnel type : ISATAP
To Next Page
Loading...
Need help?
General