Cisco 300 Series User Manual

802.1X Commands
49 OL-32830-01 Command Line Interface Reference Guide
2
switchxxxxxx# show running-config
.
.
.
dot1x page customization
data ********
exit
.
.
.
2.5 dot1x auth-not-req
Use the dot1x auth-not-req Interface Configuration (VLAN) mode command to
enable unauthorized devices access to a VLAN. Use the no form of this command
to disable access to a VLAN.
Syntax
dot1x auth-not-req
no dot1x auth-not-req
Parameters
N/A
Default Configuration
Access is enabled.
Command Mode
Interface (VLAN) Configuration mode
User Guidelines
A VLAN cannot be defined as an unauthenticated VLAN if it is an access VLAN or it
is the native VLAN for some ports.

Cisco 300 Series Specifications

General

Model	Cisco 300 Series
Category	Switch
Dimensions	Varies by model
Weight	Varies by model
Power over Ethernet (PoE)	Available on select models
Management	Web-based GUI, SNMP, CLI
VLANs	Up to 256
Security Features	ACLs, 802.1X, Port Security
Humidity	10% to 90% non-condensing
Ports	8, 16, 24, 48