Cisco 300 Series User Manual

802.1X Commands
71 OL-32830-01 Command Line Interface Reference Guide
2
Command Mode
Interface (Ethernet) Configuration mode
User Guidelines
The default value of this command should be changed only to adjust to unusual
circumstances, such as unreliable links or specific behavioral problems with
certain clients and authentication servers.
The command is only applied to the 802.1x authentication method.
Example
The following example sets the time interval during which the device waits for a
response to an EAP request frame from the client before resending the request to
3600 seconds.
switchxxxxxx(config)# interface gi11
switchxxxxxx(config-if)# dot1x timeout supp-timeout 3600
2.25 dot1x timeout tx-period
Use the dot1x timeout tx-period Interface Configuration mode command to set the
time interval during which the device waits for a response to an Extensible
Authentication Protocol (EAP) request/identity frame from the client before
resending the request. Use the no form of this command to restore the default
configuration.
Syntax
dot1x timeout tx-period
seconds
no dot1x timeout tx-period
Parameters
• seconds —Specifies the time interval in seconds during which the device
waits for a response to an EAP-request/identity frame from the client before
resending the request. (Range: 30–65535 seconds).
Default Configuration
The default timeout period is 30 seconds.

Cisco 300 Series Specifications

General

Brand	Cisco
Model	300 Series
Category	Switch
Language	English