Cisco 300 Series User Manual

Port Monitor Commands
741 OL-32830-01 Command Line Interface Reference Guide
38
2. Mirrored traffic is exposed to the STP state, i.e. if the port is in STP blocking, it
will not egress any mirrored traffic.
Example
The following example copies traffic for both directions (Tx and Rx) from the
source port gi12 to destination port gi11.
switchxxxxxx(config)# interface gi11
switchxxxxxx(config-if)#
port monitor gi12
switchxxxxxx(config-if)#
exit
38.2 show ports monitor
Use the show ports monitor EXEC mode command to display the port monitoring
status.
Syntax
show ports monitor
Command Mode
User EXEC mode
Example
The following example displays the port monitoring status.
switchxxxxxx> show ports monitor
Source Port
-----------
gi1 1
gi1 2
gi1 3
VLAN 9
Destination Port
----------------
gi1 4
gi1 4
gi1 4
gi1 4
Type
-------
RX,TX
RX,TX
RX
N/A
Status
--------
Active
Active
Active
Active

Cisco 300 Series Specifications

General

Brand	Cisco
Model	300 Series
Category	Switch
Language	English