Cisco 300 Series User Manual

Virtual Local Area Network (VLAN) Commands
OL-32830-01 Command Line Interface Reference Guide 1086
56
Default Configuration
Receiving Multicast transmissions is disabled.
Command Mode
Interface (Ethernet, Port Channel) Configuration mode
User Guidelines
When the port is assigned to a different Multicast-TV VLAN, it is automatically
removed from its previous VLAN and added it to the new Multicast-TV VLAN.
When an existed Multicast-TV VLAN is assigned to an access port, the multicast
messages received on a membership of the Multicast-TV VLAN are forwarded to
the access port. All messages received on the access port are bridged only into
its Access VLAN.
To register IGMP reports arriving on the access port by IGMP Snooping running on
the Multicast-TV VLAN, use the ip igmp snooping map cpe vlan command.
Example
The following example enables gi14 to receive Multicast transmissions from VLAN
11.
switchxxxxxx(config)# interface gi14
switchxxxxxx(config-if)# switchport access multicast-tv vlan 11
56.34 switchport customer multicast-tv vlan
To assign Multicast-TV VLANs to a customer port, use the switchport customer
multicast-tv vlan command in Interface (Ethernet, Port Channel) Configuration
mode. To return to the default, use the no format of the command.
Syntax
switchport customer multicast-tv vlan {add
vlan-list | remove vlan-list }
Parameters
• add vlan-list —Specifies a list of Multicast TV VLANs to add to interface.
• remove vlan-list —Specifies a list of Multicast TV VLANs to remove from
interface.

Cisco 300 Series Specifications

General

Brand	Cisco
Model	300 Series
Category	Switch
Language	English