Cisco 300 Series User Manual

IPv6 First Hop Security
OL-32830-01 Command Line Interface Reference Guide 550
25
logging binding
switchxxxxxx(config-nbr-binding)# exit
Example 3—The following example remove an attached Neighbor Binding policy:
switchxxxxxx(config)# no ipv6 neighbor binding policy policy1
Policy policy1 is applied on the following ports:
gi11, gi12
The policy1 will be detached and removed, are you sure [Y/N]Y
25.48 ipv6 neighbor binding static
To add a static entry to the Neighbor Binding table, use the ipv6 neighbor binding
static command in Global Configuration mode. To remove the static entry, use the
no form of this command.
Syntax
ipv6 neighbor binding static ipv6
ipv6-address vlan vlan-id interface interface-id
mac
mac-address
no ipv6 neighbor binding static ipv6 ipv6-address vlan vlan-id
Parameters
• ipv6 ipv6-address —IPv6 address of the static entry.
• vlan vlan-id —ID of the specified VLAN.
• interface interface-id —Adds static entries to the specified port.
• mac mac-address —MAC address of the static entry.
Default Configuration
No static entry.
Command Mode
Global Configuration mode

Cisco 300 Series Specifications

General

Brand	Cisco
Model	300 Series
Category	Switch
Language	English