Cisco 300 Series User Manual

Quality of Service (QoS) Commands
OL-32830-01 Command Line Interface Reference Guide 750
39
Default Configuration
No class map is defined for the policy map.
Command Mode
Policy-map Configuration mode.
User Guidelines
This command is only available when QoS is in advanced mode.
This is the same as creating a class map and then binding it to the policy map.
You can specify an existing class map in this command, or you can use the
access-group parameter to create a new class map.
After the policy-map is defined, use the service-policy command to attach it to a
port/port-channel.
Example
The following example defines a traffic classification (class map) called class1
containing an ACL called enterprise. The class is in a policy map called policy1.
The policy-map policy1 now contains the ACL enterprise.
switchxxxxxx(config)# policy-map policy1
switchxxxxxx(config-pmap)# class class1 access-group enterprise
39.9 show policy-map
Use the show policy-map Privileged EXEC mode command to display all policy
maps or a specific policy map.
This command is only available when QoS is in advanced mode.
Syntax
show policy-map [
policy-map-name ]
Parameters
policy-map-name—Specifies the policy map name.

Cisco 300 Series Specifications

General

Brand	Cisco
Model	300 Series
Category	Switch
Language	English