Cisco 300 Series User Manual

802.1X Commands
77 OL-32830-01 Command Line Interface Reference Guide
2
User Guidelines
The command is relevant only for single-host mode.
For BPDU messages whose MAC addresses are not the supplicant MAC address
are not discarded in Protect mode.
BPDU message whose MAC addresses are not the supplicant MAC address
cause a shutdown in Shutdown mode.
Example
switchxxxxxx(config)# interface gi11
switchxxxxxx(config-if)# dot1x violation-mode protect
2.31 show dot1x
Use the show dot1x Privileged EXEC mode command to display the 802.1X
interfaces or specified interface status.
Syntax
show dot1x [interface
interface-id | detailed]
Parameters
• interface-id —Specifies an Ethernet port.
• detailed—Displays information for non-present ports in addition to present
ports.
Default Configuration
Display for all ports. If detailed is not used, only present ports are displayed.
Command Mode
Privileged EXEC mode
Examples
The following example displays authentication information for all interfaces of the switch
supporting the full multi-sessions mode:
switchxxxxxx# show dot1x

Cisco 300 Series Specifications

General

Brand	Cisco
Model	300 Series
Category	Switch
Language	English