Address Table Commands
OL-32830-01 Command Line Interface Reference Guide 186
5
Default Configuration
Display for all interfaces. If detailed is not used, only present ports are displayed.
Command Mode
Privileged EXEC mode
Example
The following example displays dynamic addresses in all currently locked port:
Port Status Learning Current Maximum
------- -------- --------------- ---------- ----------
gi11 Disabled Lock 0 10
gi12 Disabled Lock 0 1
gi13 Disabled Lock 0 1
gi14 Disabled Lock 0 1
...
5.35 bridge multicast reserved-address
To define the action on Multicast reserved-address packets, use the bridge
multicast reserved-address Global Configuration mode command. To revert to
default, use the no form of this command.
Syntax
bridge multicast reserved-address
mac-multicast-address [ethernet-v2 ethtype |
llc sap | llc-snap pid] {discard | bridge}
no bridge multicast reserved-address
mac-multicast-address [ethernet-v2
ethtype | llc sap | llc-snap pid]
Parameters
• mac-multicast-address—MAC Multicast address in the reserved MAC
addresses range. (Range: 01-80-C2-00-00-00,
01-80-C2-00-00-02–01-80-C2-00-00-2F)
To Next Page
Loading...
Need help?
General