Cisco 300 Series User Manual

Virtual Local Area Network (VLAN) Commands
1071 OL-32830-01 Command Line Interface Reference Guide
56
• group —Specifies the group number (range: 1–2147483647)
Default Configuration
N/A
Command Mode
VLAN Database Configuration mode
User Guidelines
Forwarding of packets based on their MAC address requires setting up groups of
MAC addresses and then mapping these groups to VLANs.
Up to 256 MAC addresses (host or range) can be mapped to one or many
MAC-based VLAN groups.
Example
The following example creates two groups of MAC addresses, sets a port to
general mode and maps the groups of MAC addresses to specific VLANs.
switchxxxxxx(config)# vlan database
switchxxxxxx(config-vlan)# map mac 0000.1111.0000 32 macs-group 1
switchxxxxxx(config-vlan)# map mac 0000.0000.2222 host macs-group 2
switchxxxxxx(config-vlan)# exit
switchxxxxxx(config)# interface gi14
switchxxxxxx(config-if)# switchport mode general
switchxxxxxx(config-if)# switchport general map macs-group 1 vlan 2
switchxxxxxx(config-if)# switchport general map macs-group 2 vlan 3
56.22 switchport general map macs-group
vlan
Use the switchport general map macs-group vlan Interface Configuration mode
command to set a MAC-based classification rule. Use the no form of this command
to delete a classification rule.
Syntax
switchport general map macs-group
group vlan vlan-id

Cisco 300 Series Specifications

General

Brand	Cisco
Model	300 Series
Category	Switch
Language	English