Virtual Local Area Network (VLAN) Commands
1055 OL-32830-01 Command Line Interface Reference Guide
56
Parameters
•
vlan-id
—Specifies the default VLAN ID.
Default Configuration
The default VLAN is 1 by default.
Command Mode
VLAN Database Configuration mode
User Guidelines
This command becomes effective after reboot of the device.
Example
The following example defines the default VLAN as 2.
switchxxxxxx(config)#
vlan database
switchxxxxxx(config-vlan)#
default-vlan vlan
2
New Default VLAN ID will be active after save configuration and reboot device.
56.5 show default-vlan-membership
Use the show default-vlan-membership privileged EXEC command to view the
default VLAN membership.
Syntax
show default-vlan-membership [
interface-id
| detailed]
Parameters
•
interface-id
—Specifies an interface ID. The interface ID can be one of the
following types: Ethernet port or port-channel.
• detailed—Displays information for non-present ports in addition to present
ports.
Default Configuration
Membership in the default VLAN is displayed for all interfaces. If detailed is not
used, only present ports are displayed.
To Next Page
Loading...
Need help?
General