Cisco 300 Series User Manual

Quality of Service (QoS) Commands
OL-32830-01 Command Line Interface Reference Guide 776
39
Parameters
• dscp-list—Specifies up to 8 DSCP values, separated by spaces. (Range: 0–
63)
• queue-id—Specifies the queue number to which the DSCP values are
mapped.
Default Configuration
The default map for 4 queues is as follows.
The default map for 8 queues is as follows.
Command Mode
Global Configuration mode
Example
The following example maps DSCP values 33, 40 and 41 to queue 1.
switchxxxxxx(config)# qos map dscp-queue 33 40 41 to 1
39.29 qos trust (Global)
Use the qos trust Global Configuration mode command to configure the system to
the basic mode and trust state. Use the no form of this command to return to the
default configuration.
Syntax
qos trust
{cos | dscp}
DSCP value 0-15 16-23 24-39,48-63 40-47
Queue-ID 1 2 3 4
DSCP
value
0 1-8 9-15 16,24,
40,48-
63
17-23 25-31 33-39 32,41-
47
Queue-I
D
21 37 45 6 8

Cisco 300 Series Specifications

General

Model	Cisco 300 Series
Category	Switch
Dimensions	Varies by model
Weight	Varies by model
Power over Ethernet (PoE)	Available on select models
Management	Web-based GUI, SNMP, CLI
VLANs	Up to 256
Security Features	ACLs, 802.1X, Port Security
Humidity	10% to 90% non-condensing
Ports	8, 16, 24, 48