Cisco 300 Series User Manual

User Interface Commands
1043 OL-32830-01 Command Line Interface Reference Guide
55
To reset the command history buffer size to the default value, use the no form of
this command.
Syntax
history size
number-of-commands
no history size
Parameters
number-of-commands—Specifies the number of commands the system records
in its history buffer.
Default Configuration
The default command history buffer size is 10 commands.
Command Mode
Line Configuration Mode
User Guidelines
This command configures the command history buffer size for a particular line. It is
effective from the next time that the user logs in via console/telnet/ssh.
Use the terminal history size User EXEC mode command to configure the
command history buffer size for the current terminal session.
The allocated command history buffer is per terminal user, and is taken from a
shared buffer. If there is not enough space available in the shared buffer, the
command history buffer size cannot be increased above the default size.
Example
The following example changes the command history buffer size to 100 entries for
Te l n e t .
switchxxxxxx(config)# line telnet
switchxxxxxx(config-line)# history size
100

Cisco 300 Series Specifications

General

Brand	Cisco
Model	300 Series
Category	Switch
Language	English