Introduction
OL-32830-01 Command Line Interface Reference Guide 36
1
Sample of these various options are shown in the example below:
NOTE See Loopback Interface for a description of the loopback interface.
Interface Range
Interfaces may be described on an individual basis or within a range. The interface
range command has the following syntax:
<interface-range> ::=
{<port-type>[ ][/<first-port-number>[ - <last-port-number]} |
port-channel[ ]<first-port-channel-number>[ -
<last-port-channel-number>] |
tunnel[ ]<first-tunnel-number>[ - <last-tunnel-number>] |
vlan[ ]<first-vlan-id>[ - <last-vlan-id>]
A sample of this command is shown in the example below:
Interface List
A combination of interface types can be specified in the interface range
command in the following format:
<range-list> ::= <interface-range> | <range-list>, <
interface-range>
Up to five ranges can be included.
switchxxxxxx(config)#interface GigabitEthernet 1
switchxxxxxx(config)#interface GE1
switchxxxxxx(config)#interface gi1
switchxxxxxx(config)#interface po1
switchxxxxxx(config)# interface vlan 1
switchxxxxxx#configure
switchxxxxxx(config-if)#interface range gi1-5
To Next Page
Loading...
Need help?
General