Quality of Service (QoS) Commands
OL-32830-01 Command Line Interface Reference Guide 770
39
Parameters
• buffers—Displays the buffer settings for the interface's queues. For GE
ports, displays the queue depth for each of the queues.
• queueing—Displays the queue's strategy (WRR or EF), the weight for WRR
queues, the CoS to queue map and the EF priority.
• policers—Displays all the policers configured for this interface, their
settings, and the number of policers currently unused (on a VLAN).
• shapers—Displays the shaper of the specified interface and the shaper for
the queue on the specified interface.
• rate-limit—Displays the rate-limit configuration.
•
interface-id
—Specifies an interface ID. The interface ID can be one of the
following types: Ethernet port, or Port-channel.
Default Configuration
N/A
Command Mode
Privileged EXEC mode
User Guidelines
If no parameter is specified with the show qos interface command, the port QoS
mode (DSCP trusted, CoS trusted, untrusted, and so on), default CoS value,
DSCP-to-DSCP- map (if any) attached to the port, and policy map (if any) attached
to the interface are displayed. If a specific interface is not specified, the
information for all interfaces is displayed.
In case of Policers, Shapers and Rate Limit - only the ports which are not in the
default configuration will be showed.
Examples
Example 1—The following is an example of the output from the show qos interface
command.
switchxxxxxx(config)#
show qos interface
gi11
Ethernet gi10/1
To Next Page
Loading...
Need help?
General