5. Programming on the device
5.5 Transferring programs from and to a memory card
5.5 Transferring programs from and to a memory card
easyE4 base devices can be used with a microSD memory card.
For more information on the various ways in which this memory card can be used,
please refer to: → Section "microSD memory card", page 487
Programs are normally transferred from easySoft 7 to the device so that they can be
run on the device.
If the easyE4 base device has a microSD memory card, the program can also be stored
on this memory card.→ Section "Automatic booting from the card", page 488
You can store multiple programs on a single memory card.
One of these programs can be set as the boot program, i.e., this boot program will be
automatically transferred to the device and run as soon as there is a supply voltage
present (the device is turned on) and there is no program on the device itself.
Programs can be transferred on the easyE4 device itself. They can also be transferred
with easySoft 7 if the latter is connected to the easyE4.
150
easyE4 11/18 MN050009 EN www.eaton.com
To Next Page
Loading...
Need help?
General