2. Installation
2.2 Unpacking and checking the equipment supplied
2.2 Unpacking and checking the equipment supplied
Check the easyE4's packaging for transit damage.
Carefully remove the packaging in order to avoid damaging the device.
Check the package contents for visible transit damage.
Use the information in Installation instructions to make sure that the contents are
complete.
Keep the original packaging so that you will be able to use it in the
future if you need to transport or ship the device.
Make sure to also keep the documents enclosed with the device
and/or to give them to the end customer.
The package for the easyE4 series comes with:
Unit Description
1 x EASY-E4-...-12...C1 or
EASY-E4-...-12...CX1
1 x Installation instructions IL050020ZU
Table 3: Std. pack easyE4 control relays
Unit Description
1 x EASY-E4-...-...E1
1 x Bus connector plug EASY-E4-CONNECT1
1 x Installation instructions IL050021ZU
The easyE4 is sturdily built, but the components inside it are sensitive to excessively
strong vibrations and/or mechanical shock.
Accordingly, make sure to protect the easyE4 from mechanical loads that exceed the
scope of the unit's intended use.
The device should only be transported in its original packaging after being packed prop-
erly.
Missing parts or damage
If you notice anything wrong, please contact your distributor or
Eaton Service +49 (0) 180 5 223822 (de,en)
40
easyE4 11/18 MN050009 EN www.eaton.com
To Next Page
Loading...
Need help?
General