Eaton easyE4 series User Manual

11. Connection to other devices
11.1 Functions offline
11.1.3 Wiring test
The base device must be connected to easySoft online and be in STOP mode.
The status display must be on.
Either click on the Wiring test on/off option in the Communication menu or click on
the Wiring test button in the toolbar.
Select the device for which you want to run the wiring test (base device or expan-
sion device)
The input states will be displayed and, for each output, there will be a switch that you
can use to switch the output on and off.
WARNING! AUTOMATIC STARTUP!
If you are running a wiring test with the outputs, make sure that this
does not result in the system or machine assuming a dangerous state.
Do not, under any circumstance, leave your programming device
without first turning off the wiring test.
Use the wiring test only if you are sure that you will always know what
the response will be when switching outputs on and that this will not
endanger any people or property.
Do NOT use the wiring test with outputs remotely through a network.
Make absolutely sure than your actions do not put people or property at
risk.
Either click on the Wiring test on/off option in the Communication menu or click on
the Wiring test button in the toolbar to turn the test off.
All outputs are switched off.
Terminating communications with the base device will also switch off all outputs.
Make sure that the wiring test is off and that all outputs have a state of "OFF."
11.1.4 Group diagnostic alarms
Either click on the Group diagnostics option in the Communication menu or
click on the Group diagnostics button in the toolbar.
You will get a log message containing all the diagnostic alarms in the device.
easyE4 11/18 MN050009 EN www.eaton.com
531

Eaton easyE4 series Specifications

General

Brand	Eaton
Model	easyE4 series
Category	Relays
Language	English