12. Faults
12.3 Event
12.3 Event
Event Explanation Remedy
The ACTUAL values are not
being stored retentively.
Retention has not been switched on. Switch on retention in the
SYSTEM menu.
The RETENTION… menu is
not displayed in the SYSTEM
menu.
easyE4 device is in RUN operating mode. Select STOP mode
The retentive data is cleared
when there is a mode change
from RUN to STOP.
This behavior only occurs when using the
PW02 (pulse width modulation) function
block in easyE4.
Avoid using the PW02 function
block.
The SYSTEM menu is not dis-
played.
The device model does not feature this menu. Change easyE4 device if you need
retention
When the device is switched
on, the easyE4 switches to
STOP mode
No circuit diagram in the easyE4 device Load, input circuit diagram
RUN START is deactivated at easyE4. Activating RUN mode in Menu
SYSTEM OPTIONS.
The contacts of the BC (data
block comparison) and BT
(block transfer) function
blocks flash in the power
flow display
The display of the easyE4 is being updated to
intermediate states too frequently although
the contacts are operating properly
Ignore this section of the power
flow display.
The display is not showing
anything
No supply voltage Switch on the power supply
easyE4 device faulty Press the OK button. If no menu
appears, replace the easyE4
device.
Text displayed with too many spaces Enter text or do not activate text
output
570
easyE4 11/18 MN050009 EN www.eaton.com
To Next Page
Loading...
Need help?
General