Eaton easyE4 series User Manual

7. System settings
7.15 Configuring the memory card and device ID
7.15 Configuring the memory card and device ID
Only possible with easySoft 7.
Select the device you want from the catalog in the Project view
Click on the System settings tab.
Go to the Memory card / device ID section and look for the Card start checkbox, the
Allow overwriting via card checkbox, and the numeric input field.
To turn on, enable the checkbox by clicking on it.
To turn off, disable the checkbox by clicking on it.
If Card start, the device will access the memory card when it is switched on.
If Allow overwriting via card, it will be possible for the
program that is found on the memory card to overwrite the program stored on the
easyE4.
You can enter a six-digit number as a Program/device ID into the input field.
This ID ensures that a program will be overwritten on the
easyE4 device only if the IDs match.
See also
→ Section "Transferring programs from and to a memory card", page 150
→ chapter "7 microSD memory card", page 487
easyE4 11/18 MN050009 EN www.eaton.com
481

Eaton easyE4 series Specifications

General

Brand	Eaton
Model	easyE4 series
Category	Relays
Language	English