HEIDENHAIN MANUALPLUS 620 User Manual

HEIDENHAIN MANUALplus 620 369
4.34 M Commands
4.34 M Commands
M commands for program-run control
The effect of machine commands depends on the configuration of
your machine. On your lathe, other M commands may apply for the
listed functions. Refer to your machine manual.
Overview: M commands for program-run control
M00 Program stop
The program run stops. Cycle start resumes the
program run.
M01 Optional stop
If the Continuous run soft key is not active in
Automatic mode, the program run stops with M01.
Cycle start resumes the program run. If Continuous
run is active, the program continues without
stopping.
M18 Counting pulse
M30 End of program
M30 means “end of program” (you do not need to
program M30). If you press Cycle Start after M30,
program execution is repeated from the start of the
program.
M417 Activate protection zone monitoring
M418 Deactivate protection zone monitoring
M99 NS.. Program end with restart
M99 means end program and start again.
MANUALplus restarts program execution from:
 The start of program if no NS is entered
 The block number NS if a NS is entered
Modal functions (feed rate, spindle speed, tool number,
etc.) which are effective at the end of program remain in
effect when the program is restarted. You should
therefore reprogram the modal functions at the start of
program or at the startup block (if M99 is used).

HEIDENHAIN MANUALPLUS 620 Specifications

General

Brand	HEIDENHAIN
Model	MANUALPLUS 620
Category	Control Systems
Language	English