HEIDENHAIN MANUALPLUS 620 User Manual

HEIDENHAIN MANUALplus 620 43
1.4 Tool Programming
Replacement tools
During "simple" tool life monitoring the MANUALplus stops program
run when a tool is worn out. However, the program run is then
resumed and concluded.
If you use the tool life monitoring with replacement tools function,
the MANUALplus automatically inserts the "sister tool" as soon as the
tool is worn out. The MANUALplus does not stop the program run until
the last tool of the tool sequence of exchange is worn out.
You can define replacement tools when setting up the turret. The
"interchange chain" can contain more than one replacement tool. The
interchange chain is a part of the NC program.
In the T commands, you program the first tool to be changed.
Defining replacement tools:
Place the cursor on the previous tool and press RETURN.
Enter the identification number of the replacement tool (Tool dialog
box) and define the replacement strategy.
When using multipoint tools, you define in the replacement strategy
whether the complete multipoint tool or only the worn-out cutting
edge of the tool is to be replaced by a replacement tool:
 0: Complete tool (default): If a cutting edge of the multipoint tool is
worn out, the tool will no longer be used.
 1: Secondary cutting edge or any: Only the worn-out cutting edge of
the multipoint tool is replaced by another tool or another cutting
edge. Any other cutting edges of the multipoint tool that are not
worn out will continue to be used.

HEIDENHAIN MANUALPLUS 620 Specifications

General

Brand	HEIDENHAIN
Model	MANUALPLUS 620
Category	Control Systems
Language	English