HEIDENHAIN MANUALPLUS 620 User Manual

452 Overview of G Functions
7.3 Overview of G Commands in the MACHINING Section
Cycles for turning
Turning—Cycles Tu r n i n g — C y c l e s
Simple turning cycles Contour-based turning cycles
G80 Cycle end / simple contours Page 265 G740 Contour repeat cycle Page 257
G81 Simple longitudinal roughing Page 373 G741 Contour repeat cycle Page 257
G82 Simple face roughing Page 374 G810 Longitudinal roughing cycle Page 247
G83 Contour repeat cycle Page 375 G820 Face roughing cycle Page 249
G86 Simple recessing cycle Page 376 G830 Contour-parallel roughing cycle Page 251
G87 Transition radii Page 377 G835 Contour-parallel with neutral tool Page 253
G88 Chamfer Page 377 G860 Universal recessing cycle Page 255
Drilling cycles G869 Recess turning cycle Page 258
G36 Tapping Page 298 G870 Simple recessing cycle G22 Page 261
G71 Simple drilling cycle Page 293 G890 Finishing cycle Page 262
G72 Boring, countersinking, etc. Page 295
Thread cycles
G73 Tapping cycle Page 296 G31 Thread cycle Page 272
G74 Deep-hole drilling cycle Page 299 G32 Single thread cycle Page 276
Undercuts G33 Single thread cut (Thread single path) Page 278
G25 Undercut contour Page 190 G35 Metric ISO thread Page 280
G85 Undercut Page 284 G350 Simple longitudinal thread
G851 Undercut DIN 509 E, direct Page 286 G351 Simple longitudinal multi-start thread
G852 Undercut DIN 509 F, direct Page 287 G352 Tapered API thread Page 281
G853 Undercut DIN 76 F thread, direct Page 288 G36 Tapping Page 298
G856 Undercut type U, direct Page 289
Parting
G857 Undercut type H, direct Page 290 G859 Parting cycle Page 283
G858 Undercut type K, direct Page 291

HEIDENHAIN MANUALPLUS 620 Specifications

General

Brand	HEIDENHAIN
Model	MANUALPLUS 620
Category	Control Systems
Language	English