94
Parameters
cost: Specifies a cost for the default route advertised to the Stub or NSSA area, in the range of 0 to
167 77214.
Usage guidelines
This command takes effect only on the ABR of a stub area or the ABR/ASBR of an NSSA area.
Examples
# Configure Area 1 as a stub area, and specify the cost of the default route advertised to the stub area
as 20.
<Sysname> system-view
[Sysname] ospf 100
[Sysname-ospf-100] area 1
[Sysname-ospf-100-area-0.0.0.1] stub
[Sysname-ospf-100-area-0.0.0.1] default-cost 20
Related commands
• nssa
• stub
default-route-advertise (OSPF view)
Use default-route-advertise to redistribute a default route into the OSPF routing domain.
Use undo default-route-advertise to restore the default.
Syntax
default-route-advertise [ [ [ always | permit-calculate-other ] | cost cost | route-policy
route-policy-name | type type ] * | summary cost cost ]
undo default-route-advertise
Default
No default route is redistributed into the OSPF routing domain.
Views
OSPF view
Predefined user roles
network-admin
Parameters
always: Redistributes a default route in a Type-5 LSA into the OSPF routing domain regardless of whether
a default route exists in the routing table. Without this keyword, the router redistributes a default route
only when an active default route that does not belong to the current OSPF process exists in the IP routing
table.
permit-calculate-other: Enables OSPF to calculate default routes received from other routers. Without this
keyword, OSPF does not calculate default routes from other routers. If the router does not redistribute any
default route in a Type-5 LSA into the OSPF routing domain, the router calculates default routes from other
routers. It calculates these routes regardless of whether this keyword is specified.
To Next Page
Loading...
Need help?
General
