67
Usage guidelines
The import-route bgp command redistributes only EBGP routes. The import-route bgp allow-ibgp
command additionally redistributes IBGP routes and might cause routing loops. Therefore, use it with
caution.
This command redistributes only active routes. To view route state information, use the display ip
routing-table protocol command.
The undo import-route protocol all-processes command removes only the configuration made by the
import-route protocol all-processes command. It does not remove the configuration made by the
import-route protocol process-id command.
Examples
# Redistribute static routes into RIP, and set the cost for redistributed routes to 4.
<Sysname> system-view
[Sysname] rip 1
[Sysname-rip-1] import-route static cost 4
Related commands
default cost
maximum load-balancing
Use maximum load-balancing to specify the maximum number of equal-cost multi-path (ECMP) routes for
load balancing.
Use undo maximum load-balancing to restore the default.
Syntax
maximum load-balancing number
undo maximum load-balancing
Views
RIP view
Predefined user roles
network-admin
Parameters
number: Specifies the maximum number of ECMP routes.
Usage guidelines
By default, the maximum number of RIP ECMP routes equals the maximum number of ECMP routes
supported by the system.
If you use the max-ecmp-num command to configure the maximum number of ECMP routes supported by
the system to m, the default setting of this command is m, and the value range for this command is 1 to
m.
Examples
# Specify the maximum number of ECMP routes as 2.
<Sysname> system-view
[Sysname] rip
To Next Page
Loading...
Need help?
General
