146
Views
OSPF area view
Predefined user roles
network-admin
Parameters
ip-address: Specifies the IP address of a host.
cost: Specifies a cost for the route, in the range of 1 to 65535.
Examples
# Advertise host route 1.1.1.1 with a cost of 100.
<Sysname> system-view
[Sysname] ospf 100
[Sysname-ospf-100] area 0
[Sysname-ospf-100-area-0.0.0.0] host-advertise 1.1.1.1 100
import-route (OSPF view)
Use import-route to redistribute AS-external routes from another routing protocol.
Use undo import-route to disable route redistribution from another routing protocol.
Syntax
import-route protocol [ process-id | all-processes | allow-ibgp ] [cost cost | nssa-only | route-policy
route-policy-name | tag tag | type type ] *
undo import-route protocol [ process-id | all-processes ]
Default
OSPF does not redistribute AS-external routes from any other routing protocol.
Views
OSPF view
Predefined user roles
network-admin
Parameters
protocol: Redistributes routes from the specified protocol, which can be bgp, direct, isis, ospf, rip, or
static.
process-id: Specifies a process by its ID in the range of 1 to 65535. The default is 1. It is available only
when the protocol is rip, ospf, or isis.
all-processes: Redistributes routes from all the processes of the specified routing protocol. This keyword
takes effect only when the protocol is rip, ospf, or isis.
allow-ibgp: Redistributes IBGP routes. It is available only when the protocol is bgp.
cost cost: Specifies a route cost in the range of 0 to 16777214. The default is 1.
nssa-only: Limits the route advertisement to the NSSA area by setting the P-bit of Type-7 LSAs to 0.
Without this keyword, the P-bit of Type-7 LSAs is set to 1. If the router acts as both an ASBR and an ABR
To Next Page
Loading...
Need help?
General
