574
permit: Specifies the permit match mode for the routing policy node. If a route matches all the if-match
clauses of the node, it is handled by the apply clauses of the node. If not, it matches against the next
node.
node node-number: Specifies a number for the node, in the range of 0 to 65535. A node with a smaller
number is matched first.
Usage guidelines
Use a routing policy to filter routing information. A routing policy can contain several nodes and each
node contains a set of if-match and apply clauses. The if-match clauses define the match criteria of the
node and the apply clauses define the actions to be taken on packets matching the criteria. The relation
between the if-match clauses of a node is logical AND. All the if-match clauses must be met. The relation
between nodes is logical OR. A packet passing a node passes the routing policy.
Examples
# Create node 10 in permit mode for routing policy policy1 and enter routing policy node view.
<Sysname> system-view
[Sysname] route-policy policy1 permit node 10
[Sysname-route-policy-policy1-10]
Related commands
display route-policy
IPv4 routing policy commands
apply fast-reroute
Use apply fast-reroute to set a backup link for fast route (FRR).
Use undo apply fast-reroute to remove the configuration.
Syntax
apply fast-reroute { backup-interface interface-type interface-number [ backup-nexthop ip-address ] |
backup-nexthop ip-address }
undo apply fast-reroute
Default
No backup link for FRR is configured.
Views
Routing policy node view
Predefined user roles
network-admin
Parameters
backup-interface interface-type interface-number: Specifies a backup output interface. If the specified
interface is a non-P2P interface (including NBMA and broadcast interfaces, such as an Ethernet interface
or a VLAN interface), you must also specify a backup next hop.
backup-nexthop ip-address: Specifies a backup next hop.
To Next Page
Loading...
Need help?
General
