530
Predefined user roles
network-admin
Parameters
level-1: Generates a default route for Level-1.
level-1-2: Generates a default route for Level-1-2.
level-2: Generates a default route for Level-2.
route-policy route-policy-name: Specifies a routing policy by its name, a case-sensitive string of 1 to 63
characters.
Usage guidelines
If no level is specified, this command generates a Level-2 default route.
You can use a routing policy to specify a level for the default route. The default route can be generated
only when the routing policy is matched by a route entry in the routing table. The apply isis level-1
command in routing policy view specifies Level-1. The apply isis level-2 command in routing policy view
specifies Level-2. The apply isis level-1-2 command in routing policy view specifies both Level-1 and
Level-2.
Examples
# Configure the router to generate a default route in a Level-2 LSP.
<Sysname> system-view
[Sysname] isis 1
[Sysname-isis-1] ipv6 default-route-advertise
Related commands
apply isis
ipv6 enable
Use ipv6 enable to enable IPv6 for an IS-IS process.
Use undo ipv6 enable to disable IPv6.
Syntax
ipv6 enable
undo ipv6 enable
Default
IPv6 is disabled for an IS-IS process.
Views
IS-IS view
Predefined user roles
network-admin
Examples
# Create IS-IS process 1, and enable IPv6 for the process.
<Sysname> system-view
[Sysname] isis 1
To Next Page
Loading...
Need help?
General
