278
• display bgp dampening parameter ipv6 unicast
default local-preference
Use default local-preference to configure a default local preference.
Use undo default local-preference to restore the default.
Syntax
default local-preference value
undo default local-preference
Default
The default local preference is 100.
Views
BGP IPv4 unicast address family view, BGP-VPN IPv4 unicast address family view, BGP IPv6 unicast
address family view, BGP-VPN IPv6 unicast address family view
Predefined user roles
network-admin
Parameters
value: Specifies a default local preference in the range of 0 to 4294967295. The larger the value, the
higher the preference.
Usage guidelines
You can also use the apply local-preference command in a routing policy to configure the local
preference for BGP routes. If no routing policy is configured, all BGP routes use the local preference set
by the default local-preference command. If a routing policy is configured, BGP routes matching the
routing policy use the local preference set by the apply local-preference command, and other BGP routes
use the local preference set by the default local-preference command.
Examples
# In BGP IPv4 unicast address family view, set the default local preference to 180.
<Sysname> system-view
[Sysname] bgp 100
[Sysname-bgp] address-family ipv4 unicast
[Sysname-bgp-ipv4] default local-preference 180
# In BGP-VPN IPv6 unicast address family view, set the default local preference to 180.
<Sysname> system-view
[Sysname] bgp 100
[Sysname-bgp] ip vpn-instance vpn1
[Sysname-bgp-vpn1] address-family ipv6 unicast
[Sysname-bgp-ipv6-vpn1] default local-preference 180
Related commands
• apply local-preference
• route-policy
To Next Page
Loading...
Need help?
General
