554
Parameters
+: Increases a cost value.
-: Decreases a cost value.
value: Specifies a cost in the range of 0 to 4294967295.
Examples
# Configure node 10 in permit mode for routing policy policy1 to set a cost of 120 for OSPF external
routes.
<Sysname> system-view
[Sysname] route-policy policy1 permit node 10
[Sysname-route-policy-policy1-10] if-match route-type external-type1or2
[Sysname-route-policy-policy1-10] apply cost 120
apply cost-type
Use apply cost-type to set a cost type for routes.
Use undo apply cost-type to restore the default.
Syntax
apply cost-type { external | internal | type-1 | type-2 }
undo apply cost-type
Default
No cost type is set for routes.
Views
Routing policy node view
Predefined user roles
network-admin
Parameters
external: Sets the cost type to IS-IS external route.
internal: Sets the cost type to IS-IS internal route, or sets the MED value for a matching BGP route to the
IGP metric of the route's next hop.
type-1: Sets the cost type to OSPF Type-1 external route.
type-2: Sets the cost type to OSPF Type-2 external route.
Usage guidelines
Used for IS-IS, the apply cost-type internal command sets the cost type for a matching IS-IS route to IS-IS
internal route.
Used for BGP, the apply cost-type internal command sets the MED for a matching BGP route learned
from an IBGP peer to the IGP metric of the route's next hop before BGP advertises the route to an EBGP
peer.
Examples
# Configure node 10 in permit mode for routing policy policy1 to set the cost type for routes that have a
tag of 8 to IS-IS internal route.
To Next Page
Loading...
Need help?
General
